Category: 3D Printing & CNC
-
3D printed racing drone, part 2
My 3D printed racing drone is done. More or less. I was able to finish it a few weeks ago and even perform a maiden flight. It survived the experience, but I also discovered few problems I will have to solve before officially calling this project a success. First of all, the decision about hard…
-
Project Dualcopter – worklog #3
It's been exactly one year since my last update on Project Dualcopter. On 20th of October 2016 I've posted that there was a progress. Now, 12 months later, I once gain report, that there was a progress…. That was slow…. I've finally installed control surfaces and servos I've finally decided where LiPo will go: to…
-
Very custom FPV quadcopter for my daughter
When few months ago my older daughter (10 years old) started to express interest in FPV quadcopters, I was both happy and concerned. Happy, since I would have someone to fly with. Concerned, since she has no idea how to fly, I do not have a quadcopter for her and there is a big chance…
-
GPS Racer: worklog #9 – double rangefinder setup
My GPS Racer is less and less fun project. For last few weeks it acts as sensor platform for my attempts to bring rangefinders and terrain following modes back to INAV. This time in a way that will work. Two weeks ago it was carrying HC-SR04 sonar (crappy device). Week ago it was carrying US-100…
-
Depron Airboat Worklog #3
In the beginning, sorry for small delay. I’ve finished this project 4 weeks ago, but somehow it always missed schedule. Anyhow, depron airboat with 3D printed propulsion elements is ready!
-
Depron Airboat Worklog #2
Next week passed and Depron Airboat is almost ready. Almost, since it still needs some finishing and I’m missing a BEC. Turned out that total power usage of one 9g servo and FrSky X4R receiver is slightly too high to just use single LM7805. 350mA during servo movement means more that 2W of heat ((12-5)…
-
Depron Airboat Worklog #1
One of my first DIY RC projects was a Depron Airboat I’ve build almost exactly 2 years ago. 12x6x2 inch hull, motor, servo, rudder and ESC. And honestly, I loved it. It was a great fun playing with it. Too bad, it did not survived very long. It broke in a middle of a lake…
-
3D Printed Paddle Wheel Boat
It’s not a secret, that me, and QuadMeUp, are not only about quadcopters. From time to time I like to do something completely different. When I was a child (10-12 or something like that) I loved to build boats. Simple crude design: styrofoam or bark, simple sail or DC motor and tinwire propeller. No RC…
-
3D Printed Faceplate for SkyZone SKY-01 FPV goggles
While SkyZone SKY-01 are pretty good FPV goggles, they are not very comfortable. Instead big faceplate, they only have rubber eyecups. This approach works, but well… Like always, there is a solution: 3D printed faceplate for SkyZone SKY-01. Thingieverse has at least few different designs, but I’ve chose the one from the link above. They…