Tag: 3D Printing
-
How to replace the 3d printer nozzle – Prusa i3 MK3S
The Prusa i3 nozzle is of good quality. If you treat it well, it will serve you for years. My Prusa i3 MK3S was printing without absolutely any problems for more than two years. Unfortunately, some of the failed filament experiments left too much fowling in the nozzle and although it was printing fine most…
-
A very cool, futuristic looking, 3D printed quadcopter frame
I love this part of me being a creator and an influencer, where I can show you some amazing things created by other people. And today, the joy is double, because it is an extremely cool frame designed by a guy from Spain that goes under the nickname of Micrathene FPV. What it is? Well,…
-
3D printed racing drone, part 1
I’ve been pretty busy last 2 weeks. Among other things, I’ve started to design 3D printed racing drone frame. I’m fully aware there are plenty designs available on Thingiverse, but almost all of them forgets that plastic filament is not carbon fiber laminate and what works well with carbon, will fail with filament. So, I…
-
3D Printed 433MHz Moxon Antenna With Arm And Snap Mount
It’s still middle of winter here in northern hemisphere, but I’m slowly preparing for next flying season. One of my goals is to push my DIY HC-12 Telelemetry System to a next level. In both range and quality. For quality I’m planning small hardware LTM decoder with LCD. For range, I want to reach at…