Category: RC & FPV
-
EMAX SimonK Series 30A ESC
You want to know the secret? I’m cheap. I almost never buy expensive stuff. It’s not that I can not afford it and buy cheapest stuff available. In my opinion, both ways are wrong. I buy things that position themselves somewhere in the middle. Not the cheapest, not “the best” and most expensive? Why not…
-
Setting up iNav on 250 class racer
Although iNav (iNavFlight) with advanced GPS and navigation support is best suited for larger, GPS equipped drones, there is absolutely no reason not to use it on something smaller like 250 racer. Why? Well, why not? Basic flight mechanics is the same like in Cleanflight or Betaflight. FP-PID is brand new PID controller, not very…
-
Magical LiPo tree
Since LiPo batteries are potentially dangerous, they can not be just put into garbage. They have to be properly handled, utilized, before they can be safely thrown out. I will write more on this topic later. Here is only a picture of my magical LiPo tree. Knife, electrical connector, 12V halogen lightbulb, some sand, a flowerpot…
-
Connecting ultrasonic rangefinder (Sonar) to INAV
Keeping constant altitude with a drone is not a trivial task. Specially, if drone is supposed to keep give altitude very precisely few meters above the ground. One of the reasons for it is difficulty of reading precise altitude. Barometer can drift when atmospheric pressure changes and can produce a lot of noise. GPS is…
-
Smartport telemetry for Betaflight
With their latest transmitters and receivers FrSky changed telemetry protocol. XJT module, Taranis radios, X8R, X4R and X4RSB are using SmartPort telemetry protocol. And that creates few problems. First of all, SmartPort is a serial protocol. That means, flight controller has to have free serial port to connect S.Port device. Second of all, TX and…
-
What is Betaflight Air Mode?
Better late than never, so here is mine explanation what is AirMode implemented in Cleanflights fork Betaflight and hopefully soon available also in Cleanflight. Before we will go to any details, please read this to understand how PID controller works. If you know, you might skip it. In normal flight mode, No Air Mode, flight…
-
Problem: no OSD when camera is connected on minimOSD MW OSD
Problem When camera and minimOSD are connected to video transmitter, minimOSD is not overlaying OSD data. If camera is disconnected, OSD data is transmitted. After connecting camera, only camera image is transmitted. Possible Solution Check if camera and minimOSD are using the same display system. Usually monitor/goggles and video transmitter does not care very much…
-
Detecting Betaflight PID tuning issues with Blackbox: excess P gain
Almost all quadcopter PID tuning tutorials can be summarized into one sentence: “Increase P until you see oscillations, then lower it”. Plus some thoughts about I and very vague advices about D and that is all. When I got into the hobby, I’ve read all of those tutorials. And I did know more about PID…
-
DIY FPV RC Plane with foam board – The RedCruiser Project
Few months ago I’ve wrote about my first handmade Depron airplane. It was cool design. Super simple, with KFm-2 airfoil, durable and easy to fly. But it had few serious flaws: That’s why, I have build a second foamboard airplane. This time with pusher propeller mounted on a tower behind wing. Wing is almost the…